Non secured seam in copper wall
flashing is also missing solder.

Broken solder joint in copper wall flashing.

Copper wall flashing seam
was never soldered.

This inside corner was never
soldered or sealed.

The tie in to existing copper roof
was not actually tied in.

More copperwall flashing missing solder. 

We removed old leaking copper
and found standing water.

All copper was removed, and the
deck was prepared for our base of
Ice and Water Shield.

We installed Certainteed HT Ice and Water Shield to the wood deck prior to copper installation.

We installed Certainteed HT Ice and Water Shield to the wood deck prior to copper installation.

With our red rosin paper installed, we started installing the new copper roofing. 

Flat seam copper roofing installation in progress along with installed wall flashings. 

Major wood rot was found under Spanish tile roof that is adjacent to the flat seam copper roof.

Upon removal of rotten wood decking we also discovered the main beams were also rotten. 

Rotten wood was removed and replaced. Seams were supported with new steel plates. and bolted together.

Rotten wood was removed and replaced. Seams were supported with new steel plates. and bolted together.

Installed a new cedar rim board over rotten rim board.

A  unique corner detail. 

The flat seam copper roof tie in to the slopped roof in which we will install clay Spanish tile over the newly installed 3 ply system.

The flat seam copper roof is just about done. We just need to install counter flashing and coping.  

Detail of one of two exhaust vents.

Wall flashings are installed and caulked up and exhaust vents are installed.

Wall copings are installed.
Scupper box is finished and functioning.

Spanish tiled roof is installed with all flashings.